Red-MU-TEMP-45KB Programmable Temperature Transmitter

Obsolete - not available
This Article is currently not on stock. Please enter your mail and we will notify you when the product is back on stock.
Your request has been accepted
Your mail is incorrect!
The requested article couldnt be found!
An error occured!
Please accept the Privacy Policy
recommend by email
close
Please fill in all fields.
Question Type
Your E-mail Adress
My Question:
Please validate that you are not a robot.
Description
Files/Downloads

Red-MU-TEMP-45KB obsolete. Fully compatible replacement: ▸Drago DT45000.

Benefits

  • Intput for RTDs, KTY, thermocouples and other sensors/signals.
  • 3-way isolation.
  • Rugged, DIN-rail mountable, compact modules.

Programmable Temperature Transmitter

The programmable transmitter is designed for operating various industrial sensors. The measured values are converted into a current or voltage signal. The configuration can be done either via DIP switch for preference measuring ranges or extensive ranges via an USB-interface with the PC configuration program PARAset. The 3-way isolation guarantees reliable decoupling of the sensor circuit from the processing circuit and prevents linked measurement circuits from influencing each other. The auxiliary power can either be supplied via the connection terminals or via the In-Rail-Bus connector.

  • Compact, programmable, DIN-rail mountable temperature transmitter.
  • Configuration via DIP switch or extensive ranges via an USB-interface with PC configuration program PARAset.
  • 3-way isolation guarantees reliable decoupling of sensor circuit from processing circuit.
  • Sensor inputs:
    Pt100, Pt200, Pt500, Pt1000 (span min. 50 K).
    Ni100, Ni200, Ni500, Ni1000 (span min. 50 K).
    KTY (span min. 50 K).
    Resistor (100 Ω).
    Sensor current/connection 0.2 mA, 2-/3-/4-wire.
    Cable resistance <100 Ω per wire.
    Thermocouple type E, J, K, L, N, R, S, T, U / B, C, D (span min. 50 K/100 K).
    Cold junction compensation intern, extern Pt100, uncompensated, manual setting.
    ±100 mV, ±1000 mV (span min. 5 mV, 50 mV).
    Poti 100 Ω to 50 kΩ (span min. 10%).
  • Output:
    Current 0...20 mA, 0...10 mA | Voltage 0...10 V, 0...5 V.
    Current 4...20 mA, 2...10 mA | Voltage 2...10 V, 1...5 V.
  • Measurement rate: 4/s.
  • Power supply: 24 VDC (16.8...31.2 V, approx. 0.8 W). In-Rail-Bus for power supply.
  • Construction: 6.2 mm housing, protection type: IP 20. 35 mm DIN-rail mountable.

Other combinations on request!

Included: Module, instructions for use.