Micsig RCP500 Rogowski AC Current Probe

Obsolete - not available
This Article is currently not on stock. Please enter your mail and we will notify you when the product is back on stock.
Your request has been accepted
Your mail is incorrect!
The requested article couldnt be found!
An error occured!
Please accept the Privacy Policy
recommend by email
close
Please fill in all fields.
Question Type
Your E-mail Adress
My Question:
Please validate that you are not a robot.
Description
Files/Downloads

EOL/this product is discontinued and not available anymore from the manufacturer.

Micsig RCP500 Rogowski AC Current Probe

The RCP500 is a Rogowski AC current probe for the Micsig mobile oscilloscopes that allows Rogowski coil current measurements. Within the range, the output signal of the system and the current signal to be measured are always linear, so the accuracy will not change with the current. The RCP500 is compatible with the Micsig UPI multi-function probe interface of the new Micsig oscilloscopes, so no extra battery or power supply is required with these instruments. With other oscilloscopes it can also be USB powered and adapted to any other manufacturer's oscilloscope with the Micsig PA05 adaptor. The RCP500 can measure current signals with complex waveforms, such as transient inrush currents of power devices, sinusoidal currents of three-phase power supply systems, harmonic components of measured currents, current measurement of IGBTs and MOSFETs, etc.

  • Rogowski AC current probe.
  • Measures AC current in the range of 200 mApeak...500 Apeak.
  • Bandwidth 15 Hz...300 kHz.
  • 1% accuracy, less than 2 mV noise.
  • Powered from the Micsig oscilloscope or via USB.
  • CAT III 1000 V/CAT IV 600 V or below.

Model Overview

ModelRCP500
Bandwidth15 Hz...300 kHz (-3 dB)
Current range200 mApeak...500 Apeak
Output connectorPowered BNC/external BNC
Output sensitivity10 mV/A
Typical accuracy1%
Max. voltageAC 10 kVRMS (1 min, 50 Hz/60 Hz, Rogowski coil part only)
Output noise2 mVRMS
Conductor under test diameter≤50 mm
Power supplyMicsig UPI multi-function probe interface; adaptor (USB power)
Coil to integrator cable length2 m (customizable)
Integrator dimensions (mm)37 x 22 x 82
Rogowski coilInner diameter 50 mm (customizable); coil thickness approx. 6 mm


Information on product safety:

Manufacturer:
Shenzhen Micsig Technology Co., Ltd., 6F, Jinhuanyu Building, No. 56, Tiezai Rd, Bao'an District, Shenzhen, Guangdong/CHN
www.micsig.com

Responsible person:
Meilhaus Electronic GmbH, Am Sonnenlicht 2, 82239 Alling/DEU
info@meilhaus.com

Customers also bought